Lambda Labs TX-2A Manual page 6

Lambda Labs - Professional Acoustics
R DANGER!
R DANGER!
R DANGER!
R
DANGER!
R DANGER!
R
DANGER!
R
DANGER!
www.lambda-labs.com
Local safety regulations!
Other safety regulations may apply in different countries. If changes occur, get to know
the local regulations and if necessary, adapt them to the respective loudspeaker setup. It
is the duty and responsibility of the operator to carry out any ground setup and any flown
installation in accordance with the local regulations!
Inspection of electrical items & rigging components!
Check ALL involved electrical devices such as cables, Powercon sockets and ALL rigging
components which are involved in the rigging process of the loudspeaker before every use!
Even with the slightest doubts about the function and safety of any components, these
should not be used! This manual describes only a few rigging setup examples from the
possible variations. For further instructions, refer to the specific rigging manual of the
rigging product you like to use.
Flown loudspeakers!
When lifting a loudspeaker to make it a flown system, the lifting area of the speaker/
cluster must be secured and cleared! Standing under the loudspeaker when being raised,
is strictly forbidden! Never leave the loudspeaker unattended during the entire
installation process. Always keep watching all rigging components and connection joints
during the uplifting procedure! Stop the uplifting procedure if any uncertainty occurs!
Lambda Labs recommends to always use a second and independent safety link to upper
located suspension points after the setup is ready.
Dynamic Load (Wind Load)!
Lambda Labs does not recommend the use of Lambda Labs loudspeakers with wind forces
greater than 6 bft (12.3 m / s, 44 km / h,). If the wind force exceeds 8 bft ( (17.8 m / s, 62
km / h), clear the loudspeaker area, bring down the loudspeakers and secure them!
Setup environment!
Keep the device dry and avoid the contact to heavy dust, sand and prolonged exposure to
intense sunlight or strong vibrations and impact.For safety reasons, it is not allowed to
place any liquid containers on or near to the enclosure.
Placement & interaction with other devices!
The device should not be placed near any heat producing sources or exposed to
extremely high temperatures or below zero degrees Celsius. Sufficient ventilation should
be provided when operating the loudspeakers!
Setup area protection!
When setting up a system with stacked or flown loudspeaker arrays, secure the entire
work area with crowd control barriers. Make sure that the secured area is sufficiently
large in proportion to the height of the stack!
! 5
TX-2A Manual