Spark Plug - Echo GT-225 Operator's Manual

GT-225
2. Pull the fuel filter from the
tank.
3. Do not remove the wire coil
clamp to remove the fuel filter.
Pinch the fuel filter with the
fingers on one hand and the
fuel line with the other hand.
Pull and twist slightly to
separate.
4. Install the new filter with the
reverse action.
Note: Federal EPA regulations
require all model year
2012 and later gasoline powered engines produced for sale
in the United States to be equipped with a special low
permeation fuel supply hose between the carburetor and fuel
tank. When servicing model year 2012 and later equipment,
only fuel supply hoses certified by EPA can be used to
replace the original equipment supply hose. Fines up to
$37,500 may be enforced for using a non-certified
replacement part.

Spark Plug

Level 2.
Parts Required:
Use only NGK BPM8Y spark plug (BPMR8Y in Canada) otherwise
severe engine damage may occur.
1. Remove spark plug and check
for fouling, worn and rounded
center electrode.
2. Clean the plug or replace with a
new one. DO NOT sand blast to
clean. Remaining sand will
damage engine.
3. Adjust spark plug gap by
bending outer electrode.
4. Tighten spark plug to 130-170 kgf•cm (112-150 lbf•in.).
X7732273904
© 04/21 ECHO Incorporated
Tune-Up Kit
MAINTENANCE
0.65 mm (0.026 in.)
31