RIDGID 019670004701 Operator's Manual page 8

OPERATION
AM/FM TUNING
See Figure 4, page 13.
The left and right arrow buttons and the MODE button are
used to tune to the desired radio frequency. The selected
frequency is displayed on the LCD.
 Press the MODE button until AM or FM is highlighted.
 Press and release the left arrow button to tune to a lower
frequency. Press and release the right arrow button to
tune to a higher frequency.
Briefly push either button (not press and hold) to tune one
frequency step at a time.
 To SEEK, press and hold desired arrow button for 3 sec-
onds to tune to the next frequency with clear reception.
 To SCAN, press and hold both arrow buttons for 3 sec-
onds to scan through all the frequencies with clear
reception.
NOTE: When scanning, the radio will stop on frequencies
with clear reception for three seconds before continuing
to the next higher frequency.
Press PRESETS to stop scanning and select a frequency.
If no frequency is selected, the radio will return to the
frequency that was displayed when the scan was started.
STORING A PRESET IN MEMORY
See Figure 4, page 13.
The memory feature saves up to 20 frequencies as presets
in the radio's memory. You can save 10 frequencies in FM
mode and 10 in AM mode.
To store a frequency in memory:
 Tune to the frequency you want to save.
 Press and hold the PRESET button for 3 seconds. A
memory location number will blink on and off.
 Press either arrow button to scroll through the preset
positions.
 Press the PRESET button to store the frequency in the
selected memory location.
To recall a preset frequency:
 Press the PRESET button and quickly release to cycle
through stored frequencies.
TONE SELECTION
See Figure 4, page 13.
 Press the SOUND button to enter bass adjust mode.
 Adjust the bass setting using the volume knob.
 Press the SOUND button to save the new bass setting
and enter treble adjust mode.
 Adjust the treble setting using the volume knob.
 Press the SOUND button to save the new treble setting
and return to original operating mode.
STREAMING AUDIO USING A BLUETOOTH
ENABLED DEVICE (NOT INCLUDED)
See Figures 4 - 5, pages 13 - 14.
 Press the button to enter BLUETOOTH
can also enter BLUETOOTH
MODE button to cycle through available modes until
is highlighted.
NOTE: The radio will automatically attempt to connect
to the last device it was paired to. If no device has been
previously paired,
 Set your device to search/scan for available BLUETOOTH
signals, then select "STRM–RIDGID Jobsite Radio" from
the list. No password or PIN is required for connection.
 When the device has successfully paired with the radio,
you will hear an audible tone and
NOTE: If the radio does not pair with your device, turn
the power to the radio off, wait 5 seconds, then turn the
power back on and start the pairing process again.
 When streaming audio from a BLUETOOTH
device, press the arrow buttons on the radio to go to the
previous or next track. Press the PRESET button to cycle
between pausing and playing the audio.
NOTE: These controls may not be supported by the
BLUETOOTH
®
are using.
 To reach maximum volume when controlling the sound
using the radio's volume knob, make sure the volume on
your device is also at the maximum setting.
 To disconnect the current device to allow connection to
another BLUETOOTH
the button for 3 seconds. When
radio is ready to pair.
8 - English
mode by pressing the
®
will automatically begin blinking.
will stop blinking.
device and/or streaming application you
enabled device, press and hold
®
begins to blink, the
®
mode. You
®
®
enabled
®