Get Started - Philips SHC5100/93 User Manual

2 Get started

Note
•
Before using the headphones for the first time, charge the supplied
batteries for at least 10 hours.
• Only use Philips rechargeable shortened sleeve NiMH batteries with your
headphones. Other types of rechargeable batteries cannot be charged
with this system.
• AAA alkaline batteries can be used to operate the headphones, but cannot be
charged with this system.
•
If the volume of the audio source is insufficient, the transmitter
automatically turns off.
1
Install/Replace supplied batteries (Fig. B).
2
Install the antenna tube into the transmitter (Fig. C).
3
Power on the transmitter (Fig. D).
Red LED is on when audio source is connected.
»
Red LED blinks if no audio source is connected for two
»
minutes.
» Red LED is off if no audio source is connected for four
minutes.
4
To charge the headphones, connect the charging cable with
the headphones (Fig. E).
Headphones: red LED is off during charge.
»
Transmitter: green LED is on during charge and is off when
»
headphones are fully charged.
5
Power on the headphones and red LED is on (Fig. F).
6
Connect the audio device with the transmitter (Fig. G).
Red LED is on when audio source is connected.
»
Tip
•
If there is interference, tune the transmitter and the headphones to the
same channel (Fig. H).
EN
5