Table of Contents
Advertisement
3-7
Installing the PCI Expansion Card
Read the following guidelines before you install the PCI-e card:
• Voltages can be present within the server whenever an AC power source is connected. This
voltage is present even when the main power switch is in the off position. Ensure that the
system is powered-down and all power sources have been disconnected from the server prior to
installing a PCI card.
• Failure to observe these warnings could result in personal injury or damage to equipment.
Follow these instructions to install the PCI Expansion card:
1.
Remove the three screws securing the riser bracket to the system.
2.
Lift up the riser bracket out of system.
3.
Align the PCI-e card to the riser guide slot and insert the card in the selected slot. Make sure the
PCI-e card is properly seated.
4.
Secure the PCI-e card with a screw.
5.
Reverse steps 1 to 3 to install the riser bracket back into the system.
1
2
- 31 -
3
4
System Hardware Installation
Advertisement
Table of Contents
