Draining The Condensation Water - Siemens iQ500 WT47R461ES Installation And Operating Instructions Manual

Set the programme to position 2.
1.
The current setting will appear on the
display.
Press û (Drying Time)
2.
or termin. B(Ready In) until the
required setting appears on the
display.
Settings:
600 0 Low
¹
1800 0 High
Alter any additional appliance
3.
settings you require or save and exit
the appliance settings.
Saving and exiting the appliance
settings
Save and exit the appliance settings as
follows:
Turn the programme selector to
1.
switch off the appliance.
Wait 5 seconds.
2.
The selected settings are
Note:
retained even after the appliance has
been switched off.

Draining the condensation water

Œ
Draining the
condensation water
C ondensation will form in the appliance
D r a i n i n g t h e c o n d e n s a t i o n w a t e r
as it dries the laundry.
You must ensure that the drain hose is
connected when you operate the
appliance.
If there is no drain hose connected to
the appliance, the condensation water
from the appliance will run into the
condensation container. In this case,
you will need to empty the condensation
container each time the dryer finishes
drying the laundry, and also if it
becomes full before drying is complete.
Connect the drain hose as follows:
Remove any accessories from the
1.
drum.
Remove all items from the bag.
2.
en
31