Table of Contents
Advertisement
10. Connect the new internal speaker cable to the system board.
11. Reinstall all removed parts.
12. Place the computer in an upright position. Then, reconnect the power cord and all disconnected cables
to the computer.
Note: If a locking device is available, use it to lock the computer.
Thermal sensor
Prerequisite
Before you start, read Chapter 1 "Important safety information" on page 1 and print the following
instructions.
Before you open the computer cover, turn off the computer and wait several minutes until the computer is
cool.
Replacement procedure
1. Lay down the computer so that the computer cover facing up.
2. Remove the computer cover. See "Computer cover" on page 62.
3. Remove the front bezel. See "Front bezel" on page 63.
4. Disconnect the thermal sensor cable from the system board.
5. Press the tab.
6. Pivot the drive bay assembly upward.
.
Chapter 6
Hardware removal and installation
95
Advertisement
Table of Contents
