Anti-Tip Bracket - U-Line UCRE515 User Manual & Service Manual

USER GUIDE

Anti-Tip Bracket

FLOOR MOUNTED ANTI-TIP INSTALLATION
1. Locate two anti-tip brackets included with the kit.
2. Place the unit into the area where it will be installed.
Check the door, sides, and top for a proper fit. Also
test to make sure the door opens and closes freely.
3. Remove grille and place a mark on the floor at the
front of the unit. Also place a mark on the floor in the
center of the unit.
4. Remove the unit. Using a square, extend center line
"B" (see chart below). This line serves as the back
edge for the anti-tip brackets. From the center line,
measure "A" to the left and right. This line is the outer
edge of each bracket.
Surrounding
area (Top view)
C L
Front of unit
515
A 7 5⁄8"
B 22"
Anti-Tip Bracket
Back of unit
Back wall
518 524
9" 11 15⁄16"
22" 22"
5. Place the anti-tip brackets on the floor against the line
drawn for the outer edge. Mark spots for the screw
holes.
Surrounding
area (Top view)
brackets to floor
Front
of
unit
C
L
Back
unit
6. Use a 1/8" drill to make two starter holes and fasten
the anti-tip brackets to the floor using the screws
provided.
7. Place the unit back into position, making sure the
feet engage the anti-tip brackets properly. Check
the alignment of the lines made on the floor in step
3 with the position of the front feet to ensure proper
positioning.
9
u-line.com
Drill holes and
mount anti-tip
Back wall
of