Table of Contents
Advertisement
Quick Links
USER MANUAL
20V CORDLESS HEDGE TRIMMER
UHT01
!
Customer Service Ukoke
Tech
E:Service@ukoke.com
Te: (909)-606-4551
Customer Central: (Items Replacement)
19575 East Walnut Drive South, Units C16,
City of Industry, California 91748.
Te: (909)-734-6812
General Information
Reading and storing the instruction manual
This instruction manual accompanies this hedge trimmers. It contains important information
on setup and handling. Before using the line trimmer, read the instruction manual carefully.
This particularly applies to the safety notes. Failure to follow the contents of this instruction
manual may result in severe injury or damage to the line trimmer. Store the instruction manual
for future use. If you pass the line trimmer on to third parties, please ensure you include this
instruction manual.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Ukoke UHT01
Summary of Contents for Ukoke UHT01
- Page 1 USER MANUAL 20V CORDLESS HEDGE TRIMMER UHT01 Customer Service Ukoke Tech E:Service@ukoke.com Te: (909)-606-4551 Customer Central: (Items Replacement) 19575 East Walnut Drive South, Units C16, City of Industry, California 91748. Te: (909)-734-6812 General Information Reading and storing the instruction manual This instruction manual accompanies this hedge trimmers.
-
Page 2: Warning Symbols On The Machine
Warning symbols on the machine Symbols are used in this manual to attract your attention to possible risks. The safety symbols and the explications which accompany them must be perfectly understood. The warning themselves do not prevent the risks and cannot be a substitute for proper methods of avoiding accidents. -
Page 3: Warning Symbols On The Charger
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. Warning symbols on the charger Before use, carefully read through the user manual. The charger is for indoor use only. Protection class II. -
Page 4: Intended Use
Contains Li-ion battery. Battery must be recycles or disposed of properly. Do not dispose of batteries. Return exhausted batteries to your local collection or recycling point. INTENDED USE This Li-ion cordless grass trimmer N0E-22ET-230 is intended for cutting weed, grass or similar soft vegetation in areas that are hard to reach, e.g. - Page 5 are removed from the tool before operating the tool. 13. Risk of cut. Do not touch or try to stop the nylon line when it is rotating. 14. Disconnect the battery. Disconnect battery from the tool when not in use or when servicing or cleaning.
-
Page 6: Technical Data
26. Do not cross roads or gravel paths with the trimmer still running. NOTE: Do not switch the line trimmer on and off frequently over a short period of time, and in particular do not play with the ON/OFF switch TECHNICAL DATA Model M0E-UHT01 Voltage 20VDC No load speed 1200/min... -
Page 7: Safety Instructions
Blade brake time <1S Battery type Lithium-Ion 2.0Ah Battery capacity Battery charging time About 4 hours INTENDED USE Your hedge trimmer has been designed for trimming hedges, shrubs and brambles, not to be used for any other purpose. This tool is intended for consumer use only. Your charger has been designed for charging batteries of the type supplied with this tool, NOT ALLOWED TO CHARGE OTHER BATTERIES. - Page 8 g) If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. Use of these devices can reduce dust related hazards. 4) Power tools use and care a) Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed.
- Page 9 · In case of skin or eye contact, follow the instructions below. The battery fluid, a 25-30% solution of potassium hydroxide, can be harmful. In case of skin contact, immediately rinse with water. Neutralize with a mild acid such as lemon juice or vinegar. In case of eye contact, rinse abundantly with clean water for at least 10 minutes.
-
Page 10: Electrical Safety
ELECTRICAL SAFETY Your charger has designed for a specific mains voltage. Always check that the mains voltage corresponds to the voltage on the rating plate. Fig.A OVERVIEW(Fig.A) 1. Blade 2.Guard 3.Front handle 4.Main switch 5.Battery pack 6.Blade sheath 7. Charger 8.Charging indicator 9.Charge station ASSEMBLY Warning! Before assembly, remove the battery pack from the tool. - Page 11 Let the tool work at its own pace. Do not overload. ·CHARGING THE BATTERY(fig.C) The battery needs to be charged before first use and whenever it fails to produce sufficient power on jobs that were easily done before. When charging the battery for the first time, or after prolonged storage, it will only accept an 80% charge.
-
Page 12: Important Charging Notes
2 . Important charging notes. Longest life and best performance can be obtained if the battery pack is charged when the air temperature is between 18-24℃. Do not charge the battery pack in a very low or very high air temperature. -
Page 13: Maintenance
·SWITCH ON AND OFF (Fig.D) fig.D For your safety, this tool is equipped with a double switch system. This system prevents starting the tool inadvertently and will only allow operation while holding the tool with both hands. Switching on · Squeeze the front handle switch (1). ·... - Page 14 Ukoke Customer specialist (909)-606-4551 or by Email:Service@ukoke.com HOW TO LOCATE A Return CENTER: Return centers can be located at 19575 East Walnut Drive South, Units C16, City of Industry, California 91748. Ukoke Customer specialist (909)-734-6812 or by Email:Service@ukoke.com...
- Page 15 INC.’S, OBLIGATION UNDER THIS WARRANTY IS workmanship will be repaired or replaced without charge for STRICTLY AND EXCLUSIVELY LIMITED TO THE parts and labor by an authorized service center for UKOKE REPAIR OR REPLACEMENT OF DEFECTIVE PARTS ™ brand outdoor products.
Need help?
Do you have a question about the UHT01 and is the answer not in the manual?
Questions and answers