Related Manuals for Nuova LM1350HP
Summary of Contents for Nuova LM1350HP
- Page 1 Two in One Thermal Laminator USER MANUAL LM1350HP Please read these operating instructions before using the unit. Customer Service: 1-800-327-8508...
-
Page 3: Warning / Safety Instructions
WARNING / SAFETY INSTRUCTIONS LAMINATOR Caution! Surface may be Insert sealed edge first hot when in use. Always unplug the unit Do not operate the unit when not in use to prevent with a damaged power accidents supply cord Your safety as well as the safety of others is important to AURORA. In this manual as well as on the product are important safety instructions. - Page 4 WARNING / SAFETY INSTRUCTIONS • Close supervision is necessary when unit is used near children. • The plastic bag in which the product was packaged should be kept out of reach of children as it poses a suffocation hazard. • Do not use unit other than its intended use. PAPER TRIMMER •...
-
Page 5: Installation
LAMINATOR Warning / Safety Instructions Maximum feeding width of 13” (33 cm) Installation Operation Laminates up to a maximum thickness of 0.02” (0.5 mm) Care and Cleaning / Storage Accepts pouches up to a max. thickness of 3-5 mil (80-125 microns) Troubleshooting Service Center Voltage: 120v~60Hz / 6.0A... -
Page 6: Operation
OPERATION This machine can be used with warm laminating films. The items being laminated can be pictures, cards, documents, paper, etc. but must be no thicker than 0.02” (0.5 mm). NO CARRIER SHEET IN REQUIRED. Only use pouches intended for laminators. Make sure item in lami- nating pouch is evenly inserted. - Page 7 OPERATION When Finished Laminating: When the laminated item exits, it may be very hot and soft. Handle the lami- Caution: nated item with care. Pressing the item with a book or other heavy objects may help make it flat and smooth. JAM RELEASE LEVER (CLEAR JAMMED ITEMS) This laminator features a Jam Release lever to easily clear stuck items in the machine.
- Page 8 PAPER TRIMMER INSTALLATION As pictured, attach the holder to the dedicated slots located in the back section of the laminator. (FIG- URE 2) FIGURE 2 Upper slots: Cutting plate position Correctly position paper trimmer NOTE: • Remove paper clips and staples from papers before use. •...
- Page 9 CARE AND CLEANING / STORAGE Don't/Caution: • Do not spray or keep any aerosol products in or around laminator. • DO NOT USE CANNED AIR ON LAMINATOR. DO NOT USE AEROSOL PRODUCTS! DO NOT use any sharp or pointed articles for cleaning the inside, as this will damage the laminator. Since deposits or residue will influence the laminating results, periodically clean the rollers after use.
-
Page 10: Troubleshooting
TROUBLESHOOTING Warning: Failure to properly maintain your laminator will void the warranty. If there is a problem with your unit, check below for the symptoms and steps to resolve. If you continue to have problems, contact customer support at our Service Center. DO NOT ATTEMPT TO REPAIR BY OPEN- ING THE LAMINATOR. -
Page 11: Service Center
Or for more information, please visit our website at http://www.auroracorp.com LIMITED PRODUCT WARRANTY Your new NUOVA product is warranted to the original consumer against defects of workmanship and materials for a period of one year from the original purchase date. - Page 12 1-800-327-8508 Usa Only • 1-310-793-5650 International • Email: info@auroracorp.com • For more information, please visit us at: www.auroracorp.com 040919...
Need help?
Do you have a question about the LM1350HP and is the answer not in the manual?
Questions and answers