Subscribe to Our Youtube Channel
Related Manuals for Nuova LM992HC
Summary of Contents for Nuova LM992HC
- Page 1 Laminator with Hot & Cold settings USER MANUAL LM992HC Please read these operating instructions before using the unit. Customer Service: 1-800-327-8508...
-
Page 3: Warning / Safety Instructions
WARNING / SAFETY INSTRUCTIONS Caution! Surface may be Insert sealed edge first hot when in use. Always unplug the unit Do not operate the unit when not in use to prevent with a damaged power accidents supply cord Your safety as well as the safety of others is important to AURORA. In this manual as well as on the product are important safety instructions. -
Page 4: Installation
Warning / Safety Instructions Maximum feeding width of 9” (23 cm) Installation Operation Laminates up to a maximum thickness of 0.02” (0.5 mm) Care and Cleaning / Storage Accepts pouches up to a max. thickness of 3-5 mil (80-125 microns) Troubleshooting Service Center Voltage: 120v~60Hz / 2.2A... -
Page 5: Operation
OPERATION This machine can be used with cold or warm laminating films. The items being laminated can be pic- tures, cards, documents, paper, etc. but must be no thicker than 0.02” (0.5 mm). NO CARRIER SHEET IN REQUIRED. Only use pouches intended for laminators. Make sure item in lami- nating pouch is evenly inserted. -
Page 6: Cold Laminating
OPERATION 6. The finished laminated item will roll out through the exit slot on the back of the laminator. 7. Push control switch back to “OFF” to power off the laminator after use. COLD LAMINATING When switching over to the Cold lamination mode immediately after Hot laminating, please wait at least 60 minutes for the laminator to cool down before use. - Page 7 CARE AND CLEANING / STORAGE Don't/Caution: • Do not spray or keep any aerosol products in or around laminator. • DO NOT USE CANNED AIR ON LAMINATOR. DO NOT USE AEROSOL PRODUCTS! DO NOT use any sharp or pointed articles for cleaning the inside, as this will damage the laminator. Since deposits or residue will influence the laminating results, periodically clean the rollers after use.
-
Page 8: Troubleshooting
TROUBLESHOOTING Warning: Failure to properly maintain your laminator will void the warranty. If there is a problem with your unit, check below for the symptoms and steps to resolve. If you continue to have problems, contact customer support at our Service Center. DO NOT ATTEMPT TO REPAIR BY OPEN- ING THE LAMINATOR. -
Page 9: Service Center
Or for more information, please visit our website at http://www.auroracorp.com LIMITED PRODUCT WARRANTY Your new NUOVA product is warranted to the original consumer against defects of workmanship and materials for a period of one year from the original purchase date. - Page 10 1-800-327-8508 Usa Only • 1-310-793-5650 International • Email: info@auroracorp.com • For more information, please visit us at: www.auroracorp.com 091318...
Need help?
Do you have a question about the LM992HC and is the answer not in the manual?
Questions and answers