Commercial copying, redistribution, hiring or lending is prohibited. No part of this publication may be stored in a retrieval system or transmitted in any other form or means without written permission from Draper Tools Limited. In all cases this copyright notice must remain intact.
This guarantee applies in lieu of any other guarantee expressed or implied and variations of its terms are not authorised. Your Draper guarantee is not effective unless you can produce upon request a dated receipt or invoice to verify your proof of purchase within the guarantee period.
HEALTH & SAFETY INFORMATION 5.1 GENERAL SAFETY INSTRUCTIONS WARNING: - Before the use of this or any other lifting equipment all persons who install, operate or maintain this equipment should read and fully understand this manual. If lever hoists or any other lifting equipment presents the possibility of personal injury or damage to property, then it should not be used.
UNPACKING & CHECKING 6.1 PACKAGING After removing the packing material, make sure the product is in perfect condition and that there are no visible damaged parts. If in doubt, do not use the product and contact the dealer from whom it was purchased. The packaging materials (plastic bags, polystyrene, etc.), must be disposed of in an appropriate refuse collection container.
HEALTH & SAFETY INFORMATION Always ensure that the product is fully inspected before every use, this will prevent damage or serious injury to person. 7.1 FREQUENT INSPECTION A visual inspection is to be carried out by a trained person before every use. This inspection should consist of: - Evidence of slippage on the braking mechanisms.
OPERATION AND USE 8.1 WARNING: Before each use ensure that the lever hoist is fully inspected. Ensure that all chains are not twisted. The lever hoist must always be rigged to lift in a straight line. The hoist must always be free to swivel on the upper hook and not be disrupted in any way.
MAINTENANCE Clean the chain with a non-acid and non-caustic type solvent. 9.1 HOOK INSPECTION: Hooks damaged from chemicals, deformations or crack, or that have more than a 10 degree twist from the plane of the unbent hook or excessive opening or seat wear must be replaced. Hooks that are opened and thus allow the latch to disengage the tip, must be replaced.
Page 11
10. MAINTENANCE Dia of Max. Length No of links Chain Allowable used Hoist Capacity to Gauge Stock Chain 750kgs 203.0mm 1500kgs 7.0mm 236.8mm 3000kgs 10mm 338.3mm LUBRICATION: Lubricate the load chain with a light coating of chain oil. Be sure the lubricant reaches the bearing surfaces between the links, remove the excess oil from the chain using a cloth.
- Sales Fax: (023) 8049 4209 - General Enquiries: (023) 8026 6355 - Service/Warranty Repair Agent For aftersales servicing or warranty repairs, please contact the Draper Tools Helpline for details of an agent in your local area. YOUR DRAPER STOCKIST OAMC130514...
Need help?
Do you have a question about the 26188 and is the answer not in the manual?
Questions and answers