Cautions For Use - Matco Tools MT2420 Manual

WARNING
Users of this tool should review the chemical composition of
the work surface and any products used in conjunction with
this tool for any such chemicals prior to engaging in any
activity that creates dust and/or microscopic particles.
Users should obtain the Material Safety Data Sheets for all
identified chemicals, either from the manufacturer or their
employer, and proceed to study, understand and follow all
instructions and warnings for exposure to such chemicals.
Some examples of these chemicals are: lead from lead based
paints; crystalline silica from bricks, cement and other
masonry products; and arsenic and chromium from chemically
treated lumber. A listing of the chemicals can be obtained
at www.oehha.ca.gov under Proposition 65.
In order to reduce their exposure to such chemicals
users should always:
- work in well-ventilated areas
- wear appropriate safety equipment and clothes that are
specifically designed to filter out microscopic particles
The oil and water extractor should not be mounted on or near the
air compressor. The temperature of air is greatly increased during
compression. As the air cools down to room temperature in the
air line, on its way to the air power tool, the moisture contained
in it condenses. Thus, for maximum effectiveness, the oil and
water extractor should be mounted at some point
Pitch pipe back toward air receiver
Compressor unit
Drain
Daily
MICRO 2" SANDER
- .4HP
in the air supply system where the temperature of the compressed
air in the line is likely to be lowest. Air lines must be properly drained
daily. Each low point in an air line acts as a water trap. Such points
should be fitted with an easily accessible drain. See diagram below.
Pitch all air lines back towards the compressor so that condensed
moisture will flow back into the air receiver where it can be drained
off. Drain daily.
SUGGESTED AIR LINE CONNECTION
PIPE SIZE, I.D. (Inches)
Air Flow Length of Pipe (feet)
CFM
50
100
10
1/2"
3/4"
20
3/4"
3/4"
30
3/4"
3/4"
40
1"
1"
50
1"
1"
70
1"
1"
Oil and water extractor should be at least 25 ft. from the compressor. Further if possible.
Page 3

CAUTIONS FOR USE

1) This tool is intended for polishing and sanding with all
types of movement e.g. rotary, orbital and reciprocat-
ing, using coated abrasive product and bonnets of
various soft materials and endless belts. Any other
use is forbidden.
2) Only use the polishing and sanding pads as recom-
mended by the pad manufacturer.
3) It is forbidden to use the grinding wheels and cut-off
wheels on this tool.
4) Ensure the max. operating speed of the pad is higher
than the rated speed of the power tool.
5) Centrally adhere sanding disc to support pad.
6) Always wear ANSI approved ear protection and
safety glasses when using this tool. Gloves and
protective clothing are recommended.
7) Personal protection and dust collection devices shall
be chosen according to the material being worked
upon. Please consult provider of such devices.
8) Release the start and stop device in case of failure of
energy supply.
9) Only use the lubricant recommended by the manufac-
turer.
Install drain at
each low point
150 200
3/4"
3/4" 3/4"
1" 1"
1" 1"
1" 1"
1-1/4" 1-1/4"
25 FEET OR MORE
MT2420
Oil and Water
Extractor
Drain
Daily
Drain
Daily
1512184-14