Assembly; Loop Handle Version - Echo SRM-236 Operator's Manual

Before you start

Assembly

Read the operator's manual carefully to ensure that you assemble the product correctly.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.

Loop handle version

Loop handle assembly
Installation of shield
Method to change shield
WARNING
Assemble loop handle (A) and bracket (C) to drive shaft assem-
bly.
Position handle in comfortable operating position and tighten
Bolts (B).
E: Arrow
Install the handle so that it does not hide any of the
safety decals.
1. Fit shield (A) to mounting portion of angle transmission and
tighten 4 bolts (B).
There are two types of shields: namely the one used exclu-
sively for nylon line cutting head and the other one used exclu-
sively for metal blade. When metal blade is used, use the
shield for metal blade.
1. Fully loosen the bolt (A) on the right side of the bracket (B)
to slide the shield. The bolt itself cannot be removed from the
bracket.
2. Pushing the button (C), slide the shield (D) to the left and re-
move it.
3. Put shield of other type (E) into groove and slide it to the right
until it stops. Be sure to tighten the bolt.
10
F: To engine
CAUTION