Panasonic PT-47WX52F Service Manual page 40

Note: Registers marked as FIXED are factory preset,
the default value must not be changed
Important note:
Write down the original values ("b" in the
adjustment mode details, figure 60) for each
address adjustment before modifying values.
Follow the procedure below to access the various
service adjustments. (Same procedures applies to
each section).
VDEF Adjustment
VSIZE
VLIN
V-S
V-I
VSYM
VCORR
CONV Adjustments
MUTE
COARS
FINE
DAF Adjustments
H-PAR
V-SAW
V-PAR
OTHER Adjustments
ACL
HHS
About format aspect switching (WX 16:9 or HX 4:3):
Widescreen 16:9 and non-widescreen 4:3 PTVs use the same
light box, for this reason is important to set it to the correct
version (16:9 or 4:3). To change the format please refer to
figure 62 on page 43.
Be sure to select the correct format for the serviced PTV.
Service Manual
CH
the seven service sub adjustment addresses. ("a" in
figure 60)
The
level of the selected service adjustments.
Description
VERTICAL SIZE
VERTICAL LINEARITY
VERTICAL S CORRECTION
VERTICAL ENDING CORRECTION
VERTICAL MAGNET
CORRECTION
VERTICAL CORRECTION
Description
DIGITAL CONV (ON/OFF)
COARSE ADJUSTMENT
FINE ADJUSTMENT
Description
HORIZONTAL PARABOLA
VERTICAL SAW
VERTICAL PARABOLA
Description
-------
-------
- 40 -
a. Press
buttons on the remote control to select any of
b. Press
buttons on the remote control to adjust the
Default Level
N/A
N/A
N/A
N/A
N/A
N/A
Default Level
00
ADJUSTMENT
ADJUSTMENT
Default Level
+317
-23
+69
Default Level
01 CO
01 CO
New Level
New Level
New Level
New Level