Panasonic PT-47WX52F Service Manual page 32

22. Confirm that green adjustment is good enough, if
adjustment is not satisfactory, repeat adjustments.
23. Enter to LINE "G-LINE" mode by pressing TV/
VIDEO.
24. LINE mode allows to move each single line
horizontally and vertically (see figure 57).
25. Begin adjustment from the center to the edge of
the screen (see figure 56)
26. Adjust to make distribute lines
Figure 56. LINE adjustment cursor positions
27. Then press "1 or 3" on the remote until red and
green appears.
Note: Since convergence adjustment will not
allows to adjust every single cross section
of the grid, it is very important to adjust, so
that overall looks best.
.
left/right
Figure 57. LINE adjustment
28. Perform adjustments for red so that red overlaps
green, do not move green.
29. Press "1 or 3" on the remote until yellow (red and
green) and blue appears, do not move green or
red.
30. Perform adjustments so that blue overlaps Yellow
(red and green).
31. Press "1 or 3" key on remote to display red, green
and blue (white).
32. At this point the crosshatch pattern should look
white
33. If the crosshatch pattern is not only white, repeat
adjustment for that color (red or blue)
Service Manual
34. Once the crosshatch pattern looks only white,
perform the adjustments for White ("POINT",
"ORIG. POINT" & "LINE"), notice that each
adjustment is only for white (red, green, blue)
35. Adjust white for a good line distribution and make
lines completely straight.
36. Press "7" key on remote, then ACTION to save
changes.
37. Press POWER then ACTION to exit convergence
adjustments (DACs menu appears).
Screen
Frame
up/down
- 32 -