Electrolux EXWADRGTT1517 Installation Instructions Manual page 12

12
Reversing Door
B) Removing Door Lock and Plastic Hole Cover
1. Locate and remove both screws from
door lock. Save screws for later.
2. Rotate the lock as you pull it out through
the front panel. Take care not to pull too
hard or too far as the lock is still attached
to the wiring harness.
3. Disconnect the wiring harness terminal
from the door lock. Set the door lock aside
for reinstallation later.
4. Pry upward the bottom of the plastic hole
cover to release it from the front panel.
You may have to use a nan-scratching
plastic knife if you are unable to release
it manually. Slide the cover down slightly
and remove it from the front panel.
2
1
C) Reinstalling Lock and Hole Cover
1. Move the plastic cover to the other side of
the front panel. Position the cover so the
"hook" is at the bottom. Insert hook into
lower slot, slide the cover down, and press
upper retention tabs into opening until
they snap into place.
2
1
2. Insert wiring harness into door lock.
3. Insert door lock into front panel and
reinstall door lock screws.
1
D) Reversing Door Assembly
1. Locate nine screws on inner door ring.
Remove each and save for reinstallation
later. Remove inner door (with hinge) and
carefully set aside.
2
x 9