ActionTec ScreenBeam Pro User Manual page 59

2. Go to the Wireless Interface Settings section, and properly configure the network
parameters.
l
Wireless Network Name (SSID) and Wireless Network Password: The SSID and
password for accessing the receiver's wireless network. The SSID is displayed when
AGO is disabled.
l
Wireless IP Address: It is the IP address of the local management web server. This IP
address is displayed in the lower part of the Ready to connect screen. It is used to
access the local management server when AGO is disabled.
Note: The Wireless IP Address must not in the range defined by Wireless DHCP IP
Start and Wireless DHCP IP End.
l
Wireless Subnet Mask: It is the subnet mask of receiver's network.
l
Wireless DHCP IP Start and Wireless DHCP IP End: These two items define the
range of IP addresses assigned to the connected devices.
Note: These network parameters works when AGO is disabled.
3. Click the Apply button, and then click OK on the pop-up message box to confirm.
55