Samsung NQ70T5511DG Installation Manual page 12

Installation instructions
3-Wire Cable from Home Power Supply - U.S. Only
IMPORTANT: Use the 3-wire cable from home power supply where local codes
permit a 3-wire connection.
A
B
C
D
E
F
Cable from home power
A.
supply
B. Junction box
C. Black wires (normally L1)
D. White wires (normally
N-neutral)
E. green wires (normally
G-ground)
F. 4-wire flexible conduit from
oven
G. Red wires (normally L2)
H. UL listed wire connectors
I. UL listed or CSA approved
conduit connector
12 English
Install_NQ5300R_NQ70R5511DG_AA_DG68-01149A-04_EN.indd 12
Connect the 2 black wires (C) together
1.
using a UL listed wire connector.
2. Connect the 2 white wires (D) and
G
the green (or bare) ground wire (of
H
the oven cable) using a UL listed wire
connector.
3. Connect the 2 red wires (G) together
using a UL listed wire connector.
I
4. Install junction box cover.
Install oven
1.
Carefully push against front oven frame.
Handle
2.
Only push the lower oven. Do not push the
upper oven. (To prevent radio frequency
leakage.)
Using 2 or more people, lift the oven
partially into the cabinet cutout. Use
the handle as shown below.
NOTE
Push against the seal area of the front
frame to push the oven into the cabinet
until the back surface of the front frame
touches the front wall of the cabinet.
CAUTION
11/11/2019 6:07:32 PM