CONTENTS Contents: Important Safety Instructions Safety information ...............2 Warnings and safety instructions appearing in this guide Unpacking your appliance ..........3 are not meant to cover all possible conditions and situa- Warranty registration .............3 tions that may occur. Common sense, caution, and care Installing your appliance ............4 must be exercised when installing, maintaining, or operat- Cabinet clearances ............4...
UNPACKING YOUR APPLIANCE Warranty Registration WARNING It is important you send in your warranty registration card immediately after taking delivery of your appliance or you can register online at: EXCESSIVE WEIGHT HAZARD http://www.twineaglesgrills.com/contactus.shtml Use two or more people to move product. Failure to do so can result in personal injury.
For this reason it is important this area not be obstructed and the grille openings kept clean. twin Eagles does not recommend the use of a custom made grille as air flow may be restricted.
INSTALLING YOUR APPLIANCE WARNING Do not remove ground prong Electrical Shock Hazard • Do not use an extension cord with this appliance. They can be hazardous and can degrade product performance. • This appliance should not, under any circumstanc- es, be installed to an un-grounded electrical supply. •...
INSTALLING THE ANTI TIP DEVICE FOR FREESTANDING INSTALLATIONS Anti-Tip WARNING Bracket Leveling Leg • ALL APPLIANCES CAN TIP RESULTING IN INJURY. • INSTALL THE ANTI-TIP Bottom View of ⁄ " BRACKET PACKED WITH Beer dispenser (54.6 cm) THE APPLIANCE. • FOLLOW THE INSTRUC- TIONS BELOW Front of cabinet...
Page 7
INSTALLING THE ANTI TIP DEVICE FOR FREESTANDING INSTALLATIONS NOTE When the floor mounted anti-tip bracket is used the mini- mum adjusted height of the cabinet is increased by ⁄ " (9 mm). "V" notches Rear Leveling leg in bracket Figure 8a Screw ⁄...
"OFF" will appear on the display. at the top left of the display below the word "Alarm" will be illuminated. Please call Twin Eagles Customer Service or If the beer dispenser is not on, "OFF" will be shown on the your dealer if this error code is displayed.
USING YOUR BEER DISPENSER Shelving If you are using a quarter barrel of beer, you can add shelf The unit is shipped with the (2) shelves taped in place in space for keeping your mugs chilled. The quarter barrel the upper and the lower shelf positions. Remove them from must set on the floor, it cannot fit on the shelf, see the refrigerator and arrange them as follows when setting Figure 16.
USING YOUR BEER DISPENSER Tools required for installation: This beer dispensing unit will support one half ( ⁄ ) barrel or one quarter ( ⁄ ) barrel. The double draft tower units can Flat bladed screwdriver support two sixth ( ⁄...
Page 12
USING YOUR BEER DISPENSER Single Dispense Tower Kit Double Dispense Tower Kit Connect ,etc..Connect ,etc..Figure 24 Figure 23 Figure 19 Double Single Dispense Hose clamps Dispense Tower use for connections Tower Hose clamps use for connections Figure 18 Coupler Figure 25 Figure 20...
Page 13
USING YOUR BEER DISPENSER 4. If you are installing your keg refrigerator under a coun- Rear of counter top ter you will need to drill 5 holes in the counter top to ⁄ " mount the tower. The first hole is a 1 ⁄...
Page 14
USING YOUR BEER DISPENSER 9. Hooking up the keg coupler to the keg: Verify the cou- pler is in the "OFF" position (see Figure 33a).Align the lugs on the keg with the corresponding openings on the keg coupler and turn clockwise until the coupler stops Connect (about 90°).
USING YOUR BEER DISPENSER Optional CO tank external mounting bracket: The optional mounting bracket is designed to hold the 5# Remove foam plug cylinder that comes with the beer dispenser. Larger from hole port cylinders may be purchased from a third party and mounted externally.
USING YOUR BEER DISPENSER Regulator (Single Dispense Tower) Regulator (Double Dispense Tower) Your beer dispenser comes equipped with a 5 pound CO Your beer dispenser comes equipped with a 5 pound CO tank and a single gauge regulator. The gauge reads the tank and a dual gauge regulator.
USING YOUR BEER DISPENSER AND CARE AND CLEANING Drain kit (All Models): The drain kit is shipped in Removable place and ready to use. To empty: Pull drain hose out of grate for clean- bottle cap, remove bottle from unit, unscrew cap and dis- ing sump area card waste and rinse bottle.
CARE AND CLEANING Cleaning and Maintaining Dispensing System Faucet Cleaning The dispensing system needs to be cleaned between Turn off the gas supply with the shutoff valve(s) under the usage to prevent spoilage and/or foul taste in your beer. regulator (see Figure 37 or 38) and open the faucet to re- lieve the pressure.
CARE AND CLEANING Tap Cleaning Kit Front Grille This is an optional item (part number S19906) Kit includes Be sure that nothing obstructs the required air flow open- everything to quickly clean tap. Includes cleaning solution, ings in front of the cabinet. At least once or twice a year, pump, mixing bottle, brush and wrench.
CARE AND CLEANING Long term storage / winterization: 1. Time to Winterize, when the daily low ambient tempera- ture is at or below 38F. CAUTION Operating of the unit at ambient temperatures below the recommended Winterization temperature will void your war- ranty.
Page 21
CARE AND CLEANING 17. Leave door open and allow to completely dry out be- fore closing door. 18. Thoroughly clean the door gasket with anti-bacterial cleaner to be followed with clean rinse water to remove any residual chemicals. 19. Thoroughly clean the exterior with a cleaner approved for stainless steel .
STAINLESS STEEL MAINTENANCE Background NOTE Stainless steel does not stain, corrode, or rust as easily as ordinary steel, but it is not stain or corrosion proof. Stain- less steels can discolor or corrode if not maintained prop- Stainless steel products should never be installed, or stored erly.
ENERGY SAVING TIPS The following suggestions will minimize the cost of operating your refrigeration appliance. 1. Do not install your appliance next to a hot appliance (cooker, dishwasher, etc.), heating air duct, or other heat sources. 2. Install product out of direct sunlight. 3.
TROUBLESHOOTING AND OBTAINING SERVICE If You Do Need Service For Your Records If you do need service, contact your dealer or Twin Eagles. Date of Purchase In any correspondence, refer to the service number and Dealer’s name serial number of your ice machine which is located on the upper left hand side of the wall liner.
Limited One Year Parts and Labor Warranty Not Supplied or Designated by Twin Eagles Twin Eagles warrants that it will supply all necessary parts The above warranties also do not apply if: and labor to repair or replace in the end user’s home or office, any component which proves to be defective in ma- •...
Need help?
Do you have a question about the TEBK24-F and is the answer not in the manual?
Questions and answers