Table of Contents
Advertisement
Fireproof precautions:
l Keep the device away from large heat source equipment, bare flames, and high-power devices,
such as electric heaters, candles, and blow drier, to eliminate safety risks.
l If there are aged cables or power socket facilities on the power supply line to or near the device,
replace them in time to eliminate safety risks. The power supply voltage of the device must meet
the input voltage requirement.
Laser Safety
Detailed description:
l Keep the optical ports of the module clean, and cap them when they are not used.
l Prevent the end faces of the optical interfaces of the module from being damaged by hard
objects.
l Exercise caution when removing and reinserting the fibers for the SC optical ports on the module.
Do not damage the ceramic sockets of optical components.
l The goldfinger unit of the module supports no more than 50 times of removal and reinsertion.
l Laser products that are safe during use, including long-term direct intrabeam viewing, even when
exposure occurs while using optical viewing instruments (eye loupes or binoculars). Class 1 also
includes high power lasers that are fully enclosed so that no potentially hazardous radiation is
accessible during use (embedded laser product).Intrabeam viewing of Class 1 laser products
which emit visible radiant energy may still produce dazzling visual effects, particularly in low
ambient light.
l Do not look into fiber end faces without eye protection using an optical meter (such as magnifier
and microscope) within 100 mm, unless you ensure that the laser output is disabled. When
operating an optical meter, observe the operation requirements.
l This device complies with IEC 60825-1: 2007-03 Rules.
Output average power:
l Under normal circumstances, the maximum optical output average power of the optical module
is 8.0dBm. In the abnormal case, output average power of the optical module is less than 11
dBm.
Nameplate information:
l Class 1 warning sign is written on the product lable, which is posted on the product.
l "Complies with 21 CFR 1040.10 and 1040.11 except for deviations Pursuant to Laser Notice
No.50,dated June 24,2007" is written on the product lable, which is posted on the product.
l The manufacturer's address and production date information is reflected in the product lable,
which is attached on the above of the product.
Feature
Laser Eye Safety
Laser Eye Safety
Electrical Safety
Agency
Standard
FDA/CDRH
CDRH 21 CFR 1040 and Laser Notice 50
IEC 60825-1:2007,Edition 2
TÜV
IEC 60825-1:2014,Edition 3
IEC 60825-2:2004+A1:2006+A2:2010
EN 60950
TÜV
2
Advertisement
Table of Contents
