Fcc Radiation Exposure Statement - Huawei Echolife EG8245Q Quick Start Manual

FCC Radiation Exposure Statement

This device complies with FCC radiation exposure limits set forth for an uncontrolled
environment and it also complies with Part 15 of the FCC RF Rules. This equipment must be
installed and operated in accordance with provided instructions and the antenna(s) used for this
transmitter must be installed to provide a separation distance of at least 20cm from all persons
and must not be co-located or operating in conjunction with any other antenna or transmitter.
End-users and installers must be provide with antenna installation instructions and consider
removing the no-collocation statement. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following.
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
NOTE
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
FAQs
The LOS indicator blinks.
l If the LOS indicator blinks once two seconds, check whether the pigtail fiber is properly
connected and the connector is clean.
l If the GPON terminal blinks twice a second, contact the service provider for help.
The PON indicator is off.
l Check whether the OPTICAL port and optical fiber is properly connected.
l The GPON terminal fails to register with the upper-layer device. Contact the service
provider for help.
The phone does not ring upon an incoming call but communication is in normal state
when the phone is in off-hook state.
l The GPON terminal provides a maximum of 60 V AC ringing current voltage. Check
whether the ringing current voltage of the phone is higher than 60 V AC. If it is higher than
60 V AC, replace it with another phone.
How can I restore factory defaults?
l Press Reset by using a needle-type object for longer than 10s to restore factory defaults
and reset the GPON terminal. If the indicator is off and then is lit, the system restarts
successfully.
10