Advertisement
Quick Links
Advertisement
Related Manuals for SENAO PCE4302AN
Summary of Contents for SENAO PCE4302AN
- Page 1 User’s Manual Model : PCE4302AN...
- Page 2 3. Hardware Installation PCE4302AN 3-1. Installation Overview PCE4302AN wireless module is design for Access Point, Router, IP Cam series and Network products. 3.2 Safety Recommendations The safety guidelines are as follows: Keep the board area clear and dust-free before, during, and after installation.
- Page 3 3.3 Maintaining Safety with Electricity Warning: Before working on a board or working near power supplies, unplug the power cord on AC units; on DC unit, disconnect the power at the circuit breaker. Follow these guidelines when working on equipment powered by electricity: Do not work alone if potentially hazardous conditions exist anywhere in your work space.
- Page 4 Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
-
Page 5: Important Note
20 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains FCC ID: U2M-PCE4302AN”. The grantee's FCC ID can be used only when all FCC compliance requirements are met. - Page 6 Industry Canada statement: This device complies with RSS-247 of the Industry Canada Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Ce dispositif est conforme à...
-
Page 7: Note Importante
respectée entre l'antenne et les utilisateurs, et 2) Le module émetteur peut ne pas être coï mplanté avec un autre émetteur ou antenne. Tant que les 2 conditions ci-dessus sont remplies, des essais supplémentaires sur l'émetteur ne seront pas nécessaires. Toutefois, l'intégrateur OEM est toujours responsable des essais sur son produit final pour toutes exigences de conformité... - Page 8 Manual Information To the End User The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user’s manual of the end product which integrates this module. The end user manual shall include all required regulatory information/warning as show in this manual.
- Page 9 et/ou des dommages aux dispositifs LAN-EL.