Fault
Appliance does not start.
Programme starts automat-
ically.
Appliance stops during the
programme or cuts out.
Mechanical damage
Fault
Appliance door cannot be
closed.
Lid on the detergent dis-
penser cannot be closed.
Cause
The mains fuse has tripped.
Mains cable is not inserted.
Appliance door is not closed
properly.
You did not wait until pro-
gramme ended.
Appliance door is not closed
properly.
Power and/or water supply
has been interrupted.
Top basket is pressing
against inner door and pre-
venting appliance door from
being closed securely.
Cause
Door lock has been activ-
ated.
Door cannot be closed due
to installation method.
Detergent dispenser or lid
are blocked by sticky deter-
gent residue.
Troubleshooting aus
Troubleshooting
Check the relevant fuse.
▶
Check whether the socket works.
1.
Check whether the mains cable is
2.
properly inserted in the socket and
on the rear of the appliance.
Close the appliance door.
▶
→ "Terminate programme",
▶
Page 32
Close the appliance door.
▶
Check the power supply.
1.
Check the water supply.
2.
Check whether the rear panel of the
▶
appliance is being pressed in by a
socket or hose holder that has not
been removed.
Arrange the tableware so that no
▶
parts project beyond the basket
and prevent the appliance door
from closing properly.
Troubleshooting
Close the appliance door with
▶
greater force.
Check whether the appliance has
▶
been installed properly.
When closed, the appliance door,
its decor or attached parts should
not knock against adjacent cabin-
ets or the worktop.
Remove detergent residue.
▶
49