LG DF22BV2B Owner's Manual page 50

50 TROUBLESHOOTING
Problem
Excess static in clothes
after drying
Clothes have damp
spots after a Sensor de
Secado (Sensor Dry)
cycle.
Trouble connecting
appliance and
smartphone to Wi-
Fi network
Possible Cause
Fabric softener is not used or
used incorrectly.
Clothes dried too long
(overdried).
Drying synthetics, permanent
press, or synthetic blends.
Very large load or very small load.
Single large item such as a
blanket or comforter.
The password for the Wi-Fi
network was entered incorrectly.
Mobile data for your smartphone
is turned on.
The wireless network name (SSID)
is set incorrectly.
The router frequency is not 2.4
ghz.
The distance between the
appliance and the router is too
far.
Solutions
Use a fabric softener or the Reducir
Estática(Reduce Static) option, if
equipped, to reduce static electricity.
Be sure to follow the manufacturer's
instructions.
Overdrying a load of laundry can cause a
buildup of static electricity. Adjust settings
and use a shorter drying time, or use
Secado Manual (Manual Dry) cycles. Select
a LESS DRY setting on Sensor de Secado
(Sensor Dry) cycles, if necessary.
These fabrics are naturally more prone to
static buildup. Try using fabric softener, or
use LESS DRY and/or shorter Tiempo de
Secado (Time Dry) time settings.
If items are too tightly packed or too sparse
the sensor may have trouble reading the
dryness level of the load. Use a Time Dry
cycle for very small loads.
Large, bulky items such as blankets or
comforters can sometimes wrap themselves
into a tight ball of fabric. The outside layers
will dry and register on the sensors, while
the inner core remains damp. When drying
a single bulky item, it may help to pause the
cycle once or twice and rearrange the item
to unwrap and expose any damp areas.
To dry a few remaining damp items from
a very large load or a few damp spots
on a large item after a sensor cycle has
completed, empty the lint trap, then set
a Tiempo de Secado (Time Dry) cycle to
finish drying the item(s).
Delete your home Wi-Fi network and begin
the registration process again.
Turn off the Mobile data on your
smartphone before registering the
appliance.
The wireless network name (SSID) should
be a combination of English letters and
numbers. (Do not use special characters.)
Only a 2.4 GHz router frequency is
supported. Set the wireless router to
2.4 GHz and connect the appliance to
the wireless router. To check the router
frequency, check with your Internet service
provider or the router manufacturer.
If the appliance is too far from the router,
the signal may be weak and the connection
may not be configured correctly. Move the
router closer to the appliance or purchase
and install a Wi-Fi repeater.