Emerson MS3108 Owner's Manual page 20

2.) Press the MEMORY/CLOCK ADJ.
button again. The Hour digits begin
flashing.
3.) Press the or
display to the correct hour.
Be sure to observe the AM/PM indicators
to make sure you are setting the Hour
correctly.
4.) Press the MEMORY/CLOCK ADJ.
button again. The Minute digits begin
flashing.
5.) Press the or
display to the correct Minute.
6.) Press the MEMORY/CLOCK ADJ. once
more.
The display stops flashing and the clock
begins to run.
NOTES:
• After pressing the MEMORY/CLOCK ADJ. button to begin setting the clock,
you must press the
otherwise the digits stop flashing and the time cannot be adjusted. If this
occurs, press the MEMORY/CLOCK ADJ. button again and then press the
or buttons within 10 seconds to adjust the display.
• The display will always show the time when the system is in the Standby
(Power Off) or AUX mode.
MS3108_062806.p65
buttons to set the
buttons to set the
or buttons to adjust the display within 10 seconds,
19
19 28/6/2006, 16:54