Advertisement
HMI Panel Installation Guide
Wiring the Power Supply
The UniStream
®
HMI Panel device requires an external 12/24VDC power supply.
▪ In the event of voltage fluctuations or non-conformity to voltage power supply
specifications, connect the device to a regulated power supply.
Connect the +V and 0V terminals as shown
in the accompanying figure.
HMI Panel Interface Connections
Use the following:
Ethernet
CAT-5e shielded cable with RJ45 connector
USB Device
Use a standard USB cable, Type mini-B
USB Host
Standard USB cable with Type-A plug
microSD
Standard microSD
Audio Out
3.5mm stereo audio plug with shielded audio cable
Installing CPU-for-Panel, Uni-I/O™ & Uni-COM™ Modules
Refer to the Installation Guides provided with these modules.
▪ Turn off system power before connecting or disconnecting any modules or devices.
▪ Use proper precautions to prevent Electro-Static Discharge (ESD).
Removing the Panel
5. Disconnect the power supply.
6. Remove all wiring and disconnect any installed devices according to the device's
installation guide.
7. Unscrew and remove the mounting brackets, taking care to support the panel to
prevent it from falling during this procedure.
The information in this document reflects products at the date of printing. Unitronics reserves the right, subject to all applicable laws, at any time, at its sole discretion, and without notice, to
discontinue or change the features, designs, materials and other specifications of its products, and to either permanently or temporarily withdraw any of the forgoing from the market.
All information in this document is provided "as is" without warranty of any kind, either expressed or implied, including but not limited to any implied warranties of merchantability, fitness for
a particular purpose, or non-infringement. Unitronics assumes no responsibility for errors or omissions in the information presented in this document. In no event shall Unitronics be liable
for any special, incidental, indirect or consequential damages of any kind, or any damages whatsoever arising out of or in connection with the use or performance of this information.
The tradenames, trademarks, logos and service marks presented in this document, including their design, are the property of Unitronics (1989) (R"G) Ltd. or other third parties and you are
not permitted to use them without the prior written consent of Unitronics or such third party as may own them
8
DOC21001-G1 REV. G00 12/20
Unitronics
Advertisement
