Advertisement
HMI Panel Installation Guide
Panel Mounting
▪ Mounting panel thickness must be less or equal to 5mm (0.2").
N
OTE
▪ Ensure that the space considerations are met.
1. Prepare a panel cut-out according to the dimensions of your model as shown in the
previous section.
2. Slide the panel into the cut-out, ensuring
that the Panel Mounting Seal is in place as
shown on the right.
3. Push the mounting brackets into their
slots on the sides of the panel as shown
below.
4. Tighten the bracket screws against the
panel. Hold the brackets securely against
the unit while tightening the screws. The
torque required is 0.35 N·m (3.1 in-lb).
When properly mounted, the panel is
squarely situated in the panel cut-out as
shown below.
Caution ▪ Do not apply torque exceeding 0.35 N·m (3.1 in-lb) of torque to tighten the
bracket screws. Using excessive force to tighten the screw can damage this
product.
USP-070-xxx: 4 mounting brackets
6
USP-156-xxx: 10 mounting brackets
USP-104-xxx: 8 mounting brackets
Unitronics
Advertisement
