Panasonic TX-47AS800T Ehelp page 71

= Note =
Not valid in Analogue
●
Timer Programming
●
received via the signal from the broadcaster or service provider.
Depending on the progress of recording, analogue channel may not be
●
selected.
When recording programmes to the USB HDD, be sure to format the USB
●
HDD and enable it to record in
Recording > USB HDD setup
To set timer programming events of this TV on the network equipment
●
(smartphone, etc.) from outside the home network
Recording > Timer Programming > Remote recording
■
Signal Supported Recording
Signal Supported Recording
information from the TV Guide; if programme start and end times are changed
by the broadcaster, the timer event will follow the change. Note that
Supported Recording
from broadcasters.
The availability of this function depends on the country and TV mode you
●
select.
is displayed on the timer event if
●
= Note =
If you edit the start time or end time of a signal supported recording event
●
by more than 10 minutes, it will no longer follow the broadcaster's changes
to the start or end time. The start and end times will become fixed.
only works reliably if correct time information is
USB Device
is Timer Programming
only works reliably if correct information is received
Signal Supported Recording
- 71 -
Setup.
which is controlled by
Signal
is set.