Advertisement
Removing and Cleaning
the Parts
1
Step
Before cleaning
Remove the power plug
Warning
Failure to unplug
may result in an
electric shock.
Wait at least 10 minutes before reinserting the power plug
into the socket.
If you insert the plug immediately, the mechanism will not
function.
Tempered glass shelves
How to remove the upper shelf
Lift the upper shelf with
both hands to take it out.
How to remove the middle and
lower shelves
Remove the middle and lower shelves
with both hands.
Reverse the steps to put
back the shelves.
w 'R QRW OHW WKH WHPSHUHG JODVV VKHOYHV
fall off.
Ice tray /
Ice storage box
Open the door.
Slide out the ice tray and remove.
Draw the ice storage
case towards you
and remove.
Cases in the Freezer
compartment
Pull the case towards you. Hold
the end on your side and lift the
case.
14
2
Step
How to clean
w
Wipe with a soft cloth soaked in lukewarm water, or remove the parts and
(Wipe the control panel with a soft, dry cloth.)
w
For stubborn dirt, wipe using water mixed with a weak concentration of kitchen
only). In particular, be sure to wipe off oily dirt because leaving it may damage
Do not use following alkaline or low alkaline kitchen detergents,
alcohol, benzene, thinner, oil, acid, scrubbers, boiling water, or
Doing so may cause the plastic parts (such as the door
or damage or rust the doors or painted surfaces.
Illustration of the MR-L710EH
To return the parts, perform the removal procedures in reverse.
3
Step
After cleaning and periodically
rinse with water.
Check the power plug and cord
detergent (neutral
For safety, clean periodically.
the plastic parts.
Unplug the power plug from the socket and check it.
Check for damage or abnormal heating on the power plug
scouring powder, powdered soap,
w
and cord.
similar substances.
Remove any dust from the power plug and surrounding area,
handles, caps and cases) to split,
and then wipe with a dry cloth.
Firmly insert the power plug into the socket.
Door seal
Dirty seal is easily
damaged and can cause
Door seal
refrigerated air to leak.
Capsule door pocket
Lift the cover by
Push the cover to one
Remove the cover
100 degrees.
side and remove it while
towards you.
pushing in the rib of the
hinge cover with your finger.
Adjustable pocket / Bottle pocket
Adjustable pocket
Bottle pocket
Alternately lift up the left and right sides (the pockets are securely
installed).
Pull towards you.
Be sure to install the Adjustable pocket and the bottle pocket
securely and correctly.
(Or else, the pocket may fall off, causing a personal injury.)
Utility case / Vegetable case
Utility case
Fully pull out the slide case.
Lift the end on your side.
Vegetable case
Lift the end on your side to pull out the
Vegetable case.
*The ceiling shelf on the upper side of
cases cannot be removed.
Warning
If the power plug or
cord is damaged or dust
accumulates, it may cause
an electric shock or a fire.
The rear of the refrigerator and the floor
Remove the support covers from the refrigerator.
Turn the adjustable supports to lift them from the floor and
move the refrigerator off the wall. Use protective materials so
as not to scratch the floor.
Wipe away all dust and soil from the rear of the refrigerator,
the wall and the floor. Wipe them clean. Air
Soot, dirt
and dust
circulation can cause dust to collect at the rear of
and on the floor under the refrigerator, creating
black soiled areas. Clean the area periodically as
it also contributes to energy saving.
Check the floor for a sign of water leaks from
the refrigerator.
Caution
Do not put your hands, fingers or feet underneath the refrigerator.
Doing so can cause injury.
Replacing lamps in compartments
LEDs in the refrigerator compartments and behind
of Vegetable case.
Contact the retail store at which you purchased this refrigerator
from or MITSUBISHI ELECTRIC SERVICE CENTRE.
Control panel
Wipe with a soft dry cloth.
*Do not use alcohol, benzene, steel wool or alkaline-base detergents.
They can cause the control panel to malfuction.
15
Advertisement
