Advertisement
ELECTRICAL CONNECTIONS
A
Typical connections
Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious damage to this unit.
The leads of the power cord and those of the connector from the car body may be different in color.
1
Connect the colored leads of the power cord in the order specified in the illustration below.
2
Connect the antenna cord.
3
Finally connect the wiring harness to the unit.
Rear ground terminal
Line out (see diagram
Antenna terminal
White with black stripe
White
Left speaker (front)
B
Connecting the external amplifier or subwoofer
You can connect an amplifier to upgrade your car stereo system.
•
Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit.
•
Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused.
Set "L/O MODE" to "REAR" (See page 12 of the
INSTRUCTIONS.)
You can connect a power amplifier for rear speakers.
JVC Amplifier
Rear speakers
Set "L/O MODE" to "WOOFER" (See page 12 of the
INSTRUCTIONS.)
You can also connect a subwoofer to the REAR LINE OUT
terminals.
JVC Amplifier
Subwoofer
*
1
Not supplied for this unit.
*
2
Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power cannot be turned on.
*
3
Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint (if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit.
*
4
Signal cord (not supplied for this unit)
)
15 A fuse
Black
*
2
Yellow
Red
Blue
Blue with white stripe
Gray with black stripe
Gray
Right speaker (front)
or
To metallic body or chassis of the car
To a live terminal in the fuse block connecting to the car battery
(bypassing the ignition switch) (constant 12 V)
To an accessory terminal in the fuse block
To the automatic antenna if any (250 mA max.)
To the remote lead of other equipment (200 mA max.)
Green with black stripe
Green
Left speaker (rear)
Remote lead
Remote lead (blue with white stripe)
2
Ignition switch
Fuse block
Purple with black stripe
Purple
Right speaker (rear)
Y-connector (not supplied for this unit)
To the remote lead of other equipment or automatic antenna if any
Front speakers
Advertisement
