Mounting And Removing X-Lock Accessories - Bosch GWX13-50 Operating/Safety Instructions Manual

▶ Mounting and Removing
X-Lock Accessories
accessories.
Incompatible
may not clamp properly resulting in per-
sonal injury and/or property damage.
of the accessory X-Lock mounting hub
surface is not above the top of the clamp-
ing height gage. Accessories that are
above the clamping height gage may not
be fixed properly and separate from the
the tool causing personal injury and/or
property damage.
sory clamping flange before use. Do not
use the tool or accessory if the accessory
mount or accessory is damaged or de-
formed. Accessories that are not clamped
properly may cause personal injury and/or
property damage.
rial on clamping surfaces and remove be-
fore use. Unwanted material can cause in-
complete clamping
personal injury and/or property damage.
cessory is moving. Make sure that the ac-
cessory has come to a complete stop be-
fore removing the accessory. Releasing
accessory while still spinning could cause
personal injury and/or property damage.
Verify that the accessory and the X-Lock
Accessory Mount are not deformed and
are free from dirt. If necessary, clean the
area around the two X-Lock Clamping
Tabs.
Verify that both X-Lock Clamping Tabs are
open (see Fig. 8) before fitting the X-Lock
accessory.
page heading
Only use Bosch
Bosch licensed X-LOCK
accessories
Confirm proper clamp-
ing by ensuring that top
Always inspect acces-
sory mount and acces-
Check for presence or
buildup of foreign mate-
and may
Never actuate X-Lock
Release Lever while ac-
Assembly
Fig. 8
or
Accessory
X-Lock
Mounting Hub
X-Lock
Accessory
Mount
Fig. 9
cause
▼ Mounting accessory to the tool
1. Place the accessory on the X-Lock Ac-
cessory Mount, by aligning the align-
ment contours of the Accessory X-Lock
Mounting Hub with the X-Lock Acces-
sory Mount on the grinder (Fig. 8).
2. Push the accessory into the X-Lock Ac-
cessory Mount. The accessory audibly
clicks as the Clamping Tabs lock into
place (Fig. 9).
3. Check that the edge of the Accessory
X-Lock Mounting Hub is correctly en-
gaged in the slots of the X-Lock Clamp-
ing Tabs (Fig. 10). If the top surface of
the Accessory X-Lock Mounting Hub is
higher than the Clamping Height Gage
(located on each side of the X-Lock Ac-
cessory Mount), the X-Lock accessory
-17-