Gear Shifting; Adjustable Clutch; Built In Work Light - Bosch HDH361 Manual

BM 2610039324 08-16 HDH361 DDH361.qxp_HDH361 8/11/16 7:25 AM Page 11

GEAR SHIFTING

Your tool is equipped with two separate gear
ranges, low gear and high gear. Low gear
provides high-torque and slower drilling
speeds for heavy duty work or for driving
screws. High gear provides faster speeds for
drilling lighter work. To change speeds slide
switch, to high speed or high torque position.
(Fig. 9).
ATTENTION: If your tool appears to be
running, but the chuck will not turn, check to
make sure the gear shifting switch is pushed
fully into desired setting.

ADJUSTABLE CLUTCH

Your tool features 25 clutch settings. Output
torque will increase as the clutch ring, is
rotated from 1 to 25. The drill "
will lock up the clutch to permit drilling and
driving heavyduty work, and also enables bits
to be changed quickly and easily in the
keyless chuck (Fig. 10).
Min.
Adjustable
Clutch
When the trigger switch is released it
activates the brake to stop the chuck quickly.
This is especially useful in the repetitive
driving and removal of screws.

BUILT IN WORK LIGHT

Your tool is also equipped with a light that turns
on automatically when the switch is activated,
for better visibility when drilling/driving (Fig. 1).
" position
FIG. 10
Max.
BRAKE
FIG. 9
HIGH
TORQUE
Gear
Shifter
DRILL/HAMMER DRILL
SELECTOR RING
The selector ring allows the tool to be set for
various drilling/hammer drilling applications.
Rotate the selector dial right or left depending
on the below applications (Fig. 11).
Drill only action: For drilling in woods, metals,
plastics or other non concrete materials.
Drill with hammer action: For drilling in
concrete, asphalt, or other similar hard
materials. The hammer drill position overrides
the clutch for hammer drilling.
FIG. 11
Selector Ring
-11-
HIGH
SPEED
Mode