Removing Collected Water - GE APER50LZ Owner's Manual

Using the Dehumidifier
Always make sure the water bucket is locked into place on the dehumidifier.

Removing Collected Water

Use the bucket. When the bucket is removed, the unit will
shut off. Empty and replace the bucket.
IMPORTANT: Do not use the hose if using the bucket to
collect water. When the hose is connected, water will flow
through it onto the floor instead of into the bucket.
NOTES:
cause some water to drip from the drain pan.
dehumidifier to operate.
Use a hose. Water can be automatically emptied into a
floor drain by attaching a garden water hose (not included).
2. Open the drain cover on the side of the unit.
drain hose
6
nozzle
to length, and lead it to the floor drain.
NOTE:
for the dehumidifier to operate.
Use the internal pump. Water can be automatically
emptied into a remote location by attaching the included
pump hose.
the tube fitting into the connector until it fits into place
(should not be able to remove the hose when pulled).
once the 3 seconds are complete.
IMPORTANT:
the bucket is full. After pump button has been activated by
holding for 3 seconds, the pump will remain on stand-by.
When bucket is full, pump will automatically begin removing
continue until pump button is deactivated.
IMPORTANT: Make sure the condensate hose is properly
connected and is not kinked, bent or cracked as this may
fully seated for the pump to work properly. Do not operate
NOTES:
dehumidifier and pump to operate.
Make sure to install hose (included) before activating the
pump.
49-5000427 Rev. 1