Advertisement
10/19
STANDARD OPERATING PROCEDURE
DO NOT use this machine unless you have been trained and assessed to a competent level in its safe use and operation, and
have been given permission to use this
Safety glasses should be worn when
operating this equipment
Safety footwear should be worn when
operating this equipment
PRE-OPERATIONAL SAFETY CHECKS
1. DO NOT exceed this rated capacity.
2. Study, understand, and follow all instructions before operating this device.
3. Retain these instructions for future reference.
4. The equipment described in this manual could be potentially dangerous if improperly or carelessly
operated. For the protection of all persons and equipment, only competently trained operators
who are critically aware of the proper operating procedures, potential dangers, and specific
application of this equipment should be allowed to use this equipment at any time.
5. Because of potential hazards associated with this type of equipment, no alterations shall be made
to this product.
6. Failure to heed all warnings contained in this manual may result in personal injury and/or property
damage.
7. All warranties applicable to this equipment are contingent on strict adherence to the operation
and maintenance procedures in this manual.
OPERATIONAL SAFETY CHECKS
•
Rated capacity is per pair! Do not exceed rated capacity.
•
Use only on hard, level surfaces capable of sustaining rated capacity loads.
•
Centre load between both sides of the ramp set.
•
Use as a matched pair to support one end of a vehicle. One pair per vehicle only.
•
Ramps are not to be used to simultaneously support both ends and/or one side of a vehicle.
•
Always chock or block the vehicles wheels before commencing any work.
•
Do not use other lifting equipment in conjunction with the ramps.
•
Ensure other persons are clear from the vehicle path and the ramps.
•
Never accelerate or brake suddenly. Proceed slowly and cautiously.
•
Do not disconnect brakes, engine, transmission components, drive train, drive shaft, universal
joints, or wheels whilst the vehicle is on the ramps.
•
No alterations shall be made to this device
•
Failure to heed these markings may result in personal injury and/or property damage.
NOTE: RATED CAPACITY IS PER PAIR ONLY! TRUCK RAMPS MUST BE USED IN PAIR AND USE ONLY ONE PAIR
PER VEHICLE.
DO NOT USE FOR ANY PURPOSE OTHER THAN THOSE USES OUTLINED ABOVE!
Made in china to TQB Brands Pty Ltd specifications
Visit us at www.tqbbrands.com.au
Long loose hair should be contained
when operating this equipment
Close fitting/protective clothing should
be worn when operating this equipment
BNTR20PN
P a g e
| 2
Advertisement
