Philips CEM250X/78 User Manual page 13

e RED
f BLUE
g BLACK
h ORANGE/
WHITE
i YELLOW
4
Connect the supplied standard connector
to the unit.
Mount in the dashboard
1
If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
• If you disconnect the car battery in
a car that has an on-board drive or
navigation computer, the computer
may lose its memory.
• If the car battery is not disconnected,
to avoid short-circuit, ensure that bare
wires do not touch each other.
2
Remove the two screws on the top of the
unit.
14 EN
Ignition key +12V DC
when ON/ACC
Motor/electric antenna
relay control lead/
Amplifi er relay control
lead
Ground
Illumination switch
To the +12V car
battery which is
energized at all times
3
Remove the mounting sleeve with the
supplied disassembly tools.
4
Ensure that car dashboard opening is
within these measurements: