Using The Repair Kit - NorthStar ORION 6 Owner's Manual

Some holes can be repaired by yourself, but others should be
repaired in an authorized service point. The following may only be
repaired at an authorized service point or factory:
▪ Holes or tears larger than 2,5 cm. (1 inch) of any type at
any point;
▪ Any hole or tear up to 5 cm. (2 inches) in proximity to a seam
▪ All kinds of seam leakage.
All these leaks usually require both internal and external patches.
The internal patch can only be done by professionals. In this
case, it is recommended that this service be organized by your
dealer.
A temporary patch can be applied by the procedure below. But
such a patch should be properly repaired at the first opportunity.
Small holes in inflatable boats can be easily patched. However,
there are some essential rules that must be followed to maximize
patch life.
All patches should be applied in a controlled environment (relative
humidity should be below 60%, and the temperature should be
in the range of 18° to 25°C (64° to 77°F). If the tube cannot
be protected from the sun, avoid using the adhesive. Temperature
affects the strength of chemical bonds. Dampness during the
bonding process is also a critical factor affecting the result. Avoid
breathing directly on areas covered by the adhesive. Some chemicals
(adhesive or solvent) used in the repair process can be highly
toxic.
NORTHSTAR ORION Owner's Manual
The following safety guidelines must be strictly followed:
▪
▪
IMPORTANT
The Northstar repair kit should be used only for patching small
holes.
Extensive damages should be repaired only by professional
technicians at NorthStar Authorized Service Points or NorthStar
factory.
40
Do not smoke in places close to adhesive or solvent, do not
approach with fire. Both are flammable.
Repairs should be made in a well-ventilated area, glue and
solvents (MEK or toluene) may be very toxic.

11.2. USING THE REPAIR KIT