Switch Panel - NorthStar ORION 6 Owner's Manual

5.2.B. SWITCH PANEL
The following is the electric switch panel. Your Northstar ORION
RIB's switch panel is equipped with circuit breakers instead of fu-
ses. In case of a problem in the electrical circuitry the breaker will
cut the electrical current. To check your circuit breakers, you need
to remove the cover of your switch panel. There are two small
holes on the side of the panel which you can use to remove the
cover. Once the cover is removed you will see the circuit breakers
with their amperage shown on them. If the button of the circuit
breaker is out you can push it in to restore circuitry.
▪ Bilge pump breaker is 15 amps
Bilge pump is fully automatic and when it is in automatic mode,
it operates independently from the main electrical switch. It can
also be operated manually with the first button on the panel.
▪ The USB charging socket breaker is 10 amps.
There is a USB charging socket inside the storage compartment on
the console. It can be used with the button on the panel.
▪ Port / starboard navigation lights breaker is 5 amps.
Port/starboard navigation lights should be used in the dark or in
other situations where you need to be visible. It is located on the
sides of the console as port – red, starboard – green.
NORTHSTAR ORION Owner's Manual
▪
Your ORION boat is equipped with a socket-type allround light.
This light is located inside the aft storage. Before use, it must
be inserted into the socket behind the helm seat. This light can
be turned on and off by the button on the panel. If your boat is
equipped with an optional hardtop or an A-frame, then your boat
is equipped with fixed anchor lights. The fixed light is placed on
top of the hardtop or the A-frame.
▪
As an optional deck lighting system, there are 5 leds in total,
with a led strip under the console and two (2) at the bow and
two (2) at the aft.
25
The allround (anchor) light breaker is 5 amps.
The breaker of the deck lighting is 5 amps.