AEG LAVAMAT 76730 User Information page 45

2. Firmly pull both hose holders off
the unit.
The special button E and the plug
3
caps D (2 ea.) and G (1 ea.) are
supplied with the unit.
3. Unscrew the two screws A using
the special button E.
4. Unscrew the four screws B using
the special button E.
5. Remove the transport rail C.
6. Screw the four screws B back in.
7. Close off the two large holes with
the plug caps D.
Attention! Push in the plug caps
so firmly that they engage in the
rear panel (this protects the inside
of the unit against splash water).
8. Remove the screw F, including the
sleeve, compression spring and
washer, with the special button E.
9. Close off the hole with the plug
cap G.
Attention! Push in the plug cap
so firmly that it engages in the
rear panel (this protects the inside
of the unit against splash water).
Setting up and connection instructions
45