AEG LAVAMAT 76730 User Information page 34

Instructions for use
Problem
No water runs in.
Fault code
appears. The indicator
RINSE+ (SPOELEN+,
RINCAGE+) flashes.
The washing machine
vibrates during opera-
tion or it is on an une-
ven surface.
The washing solution
of the main wash
froths up a lot.
Water runs out under
the washing machine.
34
Water valve is closed.
E10
Filter in screw connection of
the intake hose is blocked.
The height-adjustable screw
feet are not correctly set.
There is not much washing in
the drum (e.g. only one
dressing gown).
The water could not be com-
pletely pumped off before
spinning because the drain-
age hose is bent
or
the solution pump is blocked.
Too much detergent was
probably used.
The screw connection on the
intake hose is leaky.
The drainage hose is leaky.
The washing solution pump
cover is not correctly closed.
Washing stuck in the filling
door.
The emergency drain hose is
not properly shut off or it is
not water-tight.
Possible Cause Remedy
Open the water valve.
Close the water valve.
Unscrew the hose from the
water valve, remove the filter
and clean it under running
water.
Adjust in accordance with
the installation and connec-
tion instructions.
This does not impair the
function.
Check the laying of the
drainage hose and eliminate
the bend if necessary, or
clean the solution pump and,
if required, remove foreign
bodies from the pump hous-
ing.
Meter the detergent exactly
in accordance with the
manufacturer's information.
Tighten the intake hose
screw connection.
Check the drainage hose and
replace it if necessary.
Close cover correctly.
Stop the program, remove
washing from the filling
door, start a new program.
Shut the emergency drain
hose off properly (see section
"Performing an Emergency
Drain"). Call your after-sales
service if the emergency
drain hose is not water-tight.