Advertisement
3. Installation
A depth of at least 46mm is required to mount the speaker. Measure the depth of the area where you are
to mount the speaker, and ensure that the speaker does not obstruct any other components of the car.
Option 1: Mount on door (front or rear)
You can mount the speakers on the front/rear door of your car.
Note
•
Make sure that nothing obstructs around the mounting location of the door.
•
A hole for mounting may already be cut out of the inner panel of the door (front or rear). In this case, you need to
modify the board only.
•
Ensure that the speaker terminals, frame or magnet do not interfere with any inner parts, such as the window
mechanism in the door (when you open or close the window), etc. Also ensure that the speaker grille does not touch
any inner fittings, such as the window cranks, door handles, arm rests etc.
1
Turn off the car ignition key.
If the power is on, the click noise generated by the connection may damage the speakers.
•
2
Cut out the mounting template from the packing box.
3
Paste the template on the location selected for mounting the speaker.
4
Mark the cut-off hole and the 4 bolt holes.
5
Cut out the marked area and drill the bolt holes.
6
Remove the grille net.
7
Strip the speaker wires and connect them to the amplifier.
Black wire: connect to "-" (negative) terminal
•
Black (white lined): connect to "+" (positive) terminal
•
Note
•
Match the "left", "right", "+" and "-" terminals correctly. Revised polarity may degrade sound quality.
•
Two 4-ohm speakers, wired in stereo, present a 8 ohm load to each channel of the amplifier. Most two channel
amplifiers work well in this configuration. However, if two 4-ohm speakers, wired in parallel to a bridged two -channel
amplifier, present a 2-ohm mono load to the amplifier. Most 2-channel amplifiers do not support 2-ohm mono
operation! Amplifier damage may result!
8
Mount on the speaker as shown below.
9
Press and insert the edges of the grille net.
Tip
•
The speaker grille can be mounted without the grille net, if you like.
Option 2: Mount on rear tray
You can also mount the speakers into the surface of the rear tray.
Follow the steps in section "Option 1: Mount in door" to mount the speakers into the rear tray:
d
f
C
B
a
b
c
e
g
Advertisement
