Schwinn Tone 1 Supplement

Important Handlebar Grip Replacement Supplement

WARNING!
Grips may loosen or fracture and may cause lose of control if the grips are not replaced!
Refer to the tone owner's manual that came with your product for complete warnings and instructions.
Parts
Hex key
Included
3 mm
4 mm
5 mm
1a
L
Remove the EXISTING
handlebar grips
❶ Remove both existing grips (1a and 1b)
by turning the left grip counter-
clockwise and the right grip clockwise.
❷ Remove both washers (2a and 2b).
❸ Loosen the hex screws (3a and 3b) on
both thumb levers.
❹ Remove the thumb levers (4a and 4b)
from the handlebar.
5a 4a
L
Attach the NEW
handlebar grips
❶ Slide the new clamps
(1a and 1b) onto each side
of the handlebar.
❷ Route the wires (2a and 2b)
into each clamp slot.
❸ Slide the thumb levers
(3a and 3b)onto each side of
the grips.
❹ Insert the new grips
(4a and 4b) completely
through the thumb levers
and clamps.
Clamps
Thick side Thin side
2a 4a
View from underside of the handlebars
3a
3a 1a Thick side
faces out
2a
6a
7a
Replacement handlebar grips
L
Before
2b
4b
Note: Discard the washers,
and existing grips, they are
no longer needed.
3b
After
Thin side 3b
1b
faces in
2b
6b
7b
1b
R
4b
5b
Rotate the left grip
clockwise and the right
grip counter-clockwise
until fully tightened.
❺ Confirm the L and R sticker
(5a and 5b) on the end of
each new grip matches the
correct side.
❻ Tighten the hex screws
(6a and 6b) on the clamps
using the 4 mm hex key.
❼ Tighten the hex screws
(7a and 7b) on the thumb
levers using the 3 mm
hex key.
R
R