Power Supply
Batteries (not included)
1 Open the battery door and insert two alkaline batteries, type AAA,
R03 or UM4, as indicated in the battery compartment. (See 1).
• Incorrect use of batteries can cause electrolyte leakage and will corrode the
compartment or cause the batteries to burst:
• Do not mix battery types: e.g. alkaline with carbon zinc. Only use batteries
of the same type for the set.
• When inserting new batteries, do not try to mix old batteries with the new
ones.
• Remove the batteries if the set is not to be used for a long time.
Batteries contain chemical substances, so they should be disposed
of properly.
General information
Antennas
• For MW, the set uses a built-in antenna. Direct this antenna for best
reception by turning the whole set.
Connecting earphones
• You can connect headphones to the headphone socket.
Locking the set
• You can lock the set in any mode by sliding the LOCK key.
➜ All keys are disabled.
• To unlock the set
➜ slide the LOCK key to UNLOCK.
Basic operation
1 Insert batteries as described in Power Supply.
➜ The clock information is displayed.
• Press 2 to switch on the set.
• Press 2 again to switch to standby mode.
2 To adjust volume, turn VOL.