Advertisement
1
Remove left side cable security cover and unplug ethernet and
power cable from the device before installing the Power-over-
Ethernet (POE) Module. DO NOT install or remove the module
with either of these cables connected or the I-Series 4 will
be damaged. Damage caused by installation with the cable(s)
attached is not covered under Elo warranty.
2
Remove screw, then lift off POE docking cover.
5mm hole, x10
3
Plug Elo POE module into recess, ensuring connector on bottom of
adaptor lines up with connector on back of the I-Series 4.
Connector
4
Secure Elo POE module to the I-Series 4 using the included M3x8
screws. The power and ethernet cables can now be reconnected to the
system.
5
Optional 100x100 VESA spacer mounting: Place the spacer over the Elo
POE module before adding VESA mounting bracket.
6
Attach wallmount or stand mounting brackets (not included) with screws long
enough to pass through the POE module and into the threaded holes of the
I-Series 4 VESA mount. Maximum screw depth is 5mm.
Elo includes two types of M4x12mm screws that work with standard 2.6mm
thick VESA brackets. Other brackets may require different length screws.
VESA spacer
Advertisement
