Example
View of installed
cable adapter
20901660_EN_VACUU·BUS-CommunicationKit_V2.0_070920
3
3
Connection
Connection
3.1
3.1 Cable adapters, general
Cable adapters, general
Connect cable adapters
1. Disconnect the device power plug or switch off the power
1.
switch.
2. 2. Connect all required components of the Communication Kit
as shown in the illustrations in chapter 2.2.
3. 3. Connect the VACUU·BUS connector or socket to the
corresponding VACUU·BUS port on the device.
4. 4. Connect the USB adapter to a free USB port on your terminal
device and, if required, install the driver software from the
enclosed CD ROM.
5. 5. Refer to the manual of the VACUU·BUS component or your
laboratory software for how to install an update or establish
data transfer.
3.2
3.2 VACUU·PURE
VACUU·PURE
The cable adapter labeled
solely for VACUU·PURE vacuum pumps for updates and as a
Modbus RTU interface. Communication can only be established
with suitable software, e.g., LabVIEW, Modbus Poll, etc.
Cable adapter with VACUU·BUS socket
1
* VACUU PURE ONLY
1
Cable adapter for VACUU·BUS socket/D-sub
RS-485 / USB-A adapter
2
USB-A extension cable
3
Connection
is intended
2
3
13