Page 1
MotoTec 105CC Mini Bike FOR YOUR SAFETY, ALWAYS USE A HELMET NOTE: WE RECOMMEND THE USE OF A FULL HELMET. IT COMPLETELY COVERS THE HEAD AND PROVIDES MORE INSULATION FROM NOISE AND AIR. www.mototecusa.com WITH MOTOTEC, DO MORE MotoTec® WARRANTY POLICY, USER MANUAL, ASSEMBLY MANUAL...
Page 2
Dear Customer: Thank you for your confidence in choosing MotoTec. Your new Mini Bike model has a 4-stroke, overhead camshaft (OHC), 105cc and 3.5 hp engine, IT WAS DESIGNED AS A RECREATIONAL VEHICLE. We hope it meets your best expectations and we send you our best wishes.
Page 3
CHANGING THE ENGINE OIL TECHNICAL DATA CLEANING THE SPARK PLUG AIR FILTER CONDITIONS TO BE RESOLVED ADJUSTING THE THROTTLE POINT TIRES STORAGE SERVICES MOTOTEC If your mini bike has any problems, please contact us. www.mototecusa.com Do Not Return to the Store.
It refers to special procedures and precautions that must be followed to avoid damage to your Mini Bike. In addition, they make the maintenance easy and the instructions clearer. ECOLOGICAL NOTE : We take care of our environment. MOTOTEC If your mini bike has any problems, please contact us. www.mototecusa.com Do Not Return to the Store.
All information included in this manual is based on the latest data received from people at the time of its publication. MotoTec reserves the right to modify the manual at any time, without prior notice. No part of this manual may be reproduced in any way or by any medium, w –ithout prior written authorization from MotoTec.
WARRANTY MOTOTEC If your mini bike has any problems, please contact us. www.mototecusa.com Do Not Return to the Store.
Page 7
Policy, will be sufficient cause for the Client to pay the cost of said revision and / or repair to the Authorized MotoTec Service Center.
Page 8
1.-Have the Guarantee Certificate duly filled and stamped by the establishment where the Mini Bike was acquired. 2.-Not having made any modifications to the Mini Bike 3.-Having performed all the maintenance services indicated by an Authorized MotoTec Service Center. MOTOTEC If your mini bike has any problems, please contact us.
Page 9
(185lbs) ATTENTION Before Children use the Mini Bike, an adult is responsible for their skill level and ability MOTOTEC If your mini bike has any problems, please contact us. www.mototecusa.com Do Not Return to the Store.
Page 10
Mini Bike Cut the cinch fastening the fork with the structure. 1 person 1 person MOTOTEC If your mini bike has any problems, please contact us. www.mototecusa.com Do Not Return to the Store.
Page 11
The bottom of the clamps should Be careful not to lose the be centered with holes in fork rubber of the screws MOTOTEC If your mini bike has any problems, please contact us. www.mototecusa.com Do Not Return to the Store.
Page 12
Small washer behind cover. Largest washer in front of cover. Remove the missing pieces that hold the Mini Bike to the metal base. 1 person MOTOTEC If your mini bike has any problems, please contact us. www.mototecusa.com Do Not Return to the Store.
LOCATION OF PARTS TOP VIEW OF THE ANTERIOR (A) Rear brake lever (B) Kill Switch (C) Throttle grip MOTOTEC If your mini bike has any problems, please contact us. www.mototecusa.com Do Not Return to the Store.
Mini Bike can be turned on. Not connected When the current cut-off switch is in this position, Mini Bike cannot be turned on. MOTOTEC If your mini bike has any problems, please contact us. www.mototecusa.com Do Not Return to the Store.
Page 15
CHOKE The throttle blocks the passage of air in the fuel mixture that reaches the engine. It has 2 positions: Image 3 MOTOTEC If your mini bike has any problems, please contact us. www.mototecusa.com Do Not Return to the Store.
Gasoline burned by Silence / Exhaust contains carbon monoxide, which is harmful to your health or can cause death. Always start the engine in open places. MOTOTEC If your mini bike has any problems, please contact us. www.mototecusa.com Do Not Return to the Store.
LOCATION OF PARTS RIGHT SIDE (A) Fuel valve (B) Seat (C) Rear disc brake (D) Pull Start (E) Spark plug MOTOTEC If your mini bike has any problems, please contact us. www.mototecusa.com Do Not Return to the Store.
Important: Check that the VIN that comes with your invoice matches the VIN of your Mini Bike. Image 5. Manual Pull Start MOTOTEC If your mini bike has any problems, please contact us. www.mototecusa.com Do Not Return to the Store.
Image 7. Add gasoline. 11.Replace the oil plug. Attention: 12.Turn the oil plug clockwise. Gasoline is highly flammable and explosive. To avoid accidents you should: MOTOTEC If your mini bike has any problems, please contact us. www.mototecusa.com Do Not Return to the Store.
Page 20
To avoid injury to a person and / or damage to the Mini Bike The engine oil should be changed at the service maintenance we recommend that you go to an Authorized MotoTec (See Maintenance Services page 23). Service Center to have the oil change done.
PERIODIC REVIEWS Note: SPARK CLEANING We recommend that you go to an Authorized MotoTec For proper operation, stop the Mini Bike, the spark plug Service Center to have the spark plug cleaned. must be calibrated, clean and in good condition.
Page 22
PERIODIC REVIEWS Note: 3.Turn the adjusting screw to bring it within specification. To clean and / or replace the air filter, go to your nearest MotoTec 4. Check that the throttle free play is within the Authorized Service Center. specification, also that the rotation is smooth from the closed position to the open position.
Page 23
Rear Tire Pressure : 10-15 Pounds per square inch (psi) while driving. If you temporarily repair a tire by placing a patch or using spray sealant, drive carefully at low speed Correct when changing a tire, go to your MotoTec Authorized pressure pressure Service Center.
, in most cases, future problems likewise your Mini Bike has a warranty period which continues in force If you do not carry out maintenance services at the MotoTec Authorized Service Centers. The following table indicates the periods and activities to be performed according to a normal procedure.
Page 25
You can use special cleaning and ·Under the seat. maintenance products for synthetic materials and artificial leather ·Kill switch. that do not contain solvents. MOTOTEC If your mini bike has any problems, please contact us. www.mototecusa.com Do Not Return to the Store.
Page 26
Use a spray to dissolve grease for dry grease stains. Treat special stains like ballpoint stains marker, nail polish, etc. with a stain remover especially for synthetic materials. MOTOTEC If your mini bike has any problems, please contact us. www.mototecusa.com Do Not Return to the Store.
See Throttle Knob Adjustment, page 21. Check the tire resistance that did not present in blows, cuts, cracks or excessive wear Tires profile. See Tires, page 22. MOTOTEC If your mini bike has any problems, please contact us. www.mototecusa.com Do Not Return to the Store.
Do not let the engine run for more than 3 minutes each total since there may be overheating, remember that the cooling system is by air and not by fan. MOTOTEC If your mini bike has any problems, please contact us. www.mototecusa.com...
Page 29
2.Add engine oil. 3.Add gasoline. See Adding Gasoline page 18. 4.Set the fuel valve to the "ON" position. 5.Check tire pressure. See page 22. MOTOTEC If your mini bike has any problems, please contact us. www.mototecusa.com Do Not Return to the Store.
A full helmet and can cause accidents and damage to the Mini Bike. protective clothing that meets safety standards. MotoTec is not liable for any reason whatsoever due to overloading. To prevent accidents, avoid overloading: CLOTHES Shiny clothing made · Bulky objects weighed on the Mini Bike...
To prevent theft of your Mini Bike you must: - Always leave the Mini Bike in a safe place. - Avoid lending your Mini Bike MOTOTEC If your mini bike has any problems, please contact us. www.mototecusa.com Do Not Return to the Store.
TECHNICAL DATA C O N C E P T SPECIFICATIONS MT-MiniBike-105cc Model Dimensions Length x width dimension 1270x635mm 34kg (74lbs.) Weight Load capacity Maximum load (conductor) 61kg (135lbs.) 4 stroke Type Cooling system Motor 3.5HP Engine power Manual starter rope...
Page 34
Throttle choke in bad condition go to your nearest Authorized Service Center. Attention: Any adjustments to the Mini Bike must be made or supervised by an adult. MT-MiniBike-105cc Made In China MotoTec www.mototecusa.com 3700 Corporate Ave Plover WI 54467 MOTOTEC If your mini bike has any problems, please contact us.
Need help?
Do you have a question about the MT-MiniBike-105cc and is the answer not in the manual?
Questions and answers