Primo Water PRSF-80513 Use Instruction page 9

1. Fit outer tube onto cast iron base and secure with 4 screws,then fit cover ring onto cast coupling.
2. Screw out knob on column then fit inner tube.
3. Fit the motor into male supporter,adjust to suitable height at coupling,then lock make
supporter set screw.
4. Fit rear guard of fan into motor and secure with 4 screws.Please insure ensure these screws
are properly tightened to avoid vibration noise.
5. Fit blade to shaft and LOCK BLADE SET SCREW.
6. Fit front guard to rear guard using clips.
7. When secure cord anchorage,please ensure sufficient cord loop between motor and cord
anchorage is maintained.Insufficient loop may cause cord shorts out when fan oscillates.
5: Principle Diagram For Electric Appliances
NOTE
1. This appliance is not intended for use by persons(including children) with reduce
physical,sensory or mental capabilities,or lack of experience and knowledge,unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for their
safety.
2. If the power supply cord is damaged,it must be replaced by manufacturer or its service agent or
a similarly qualified person in order to avoid a hazard.
3. Necessary to fix a contact at lease 3 mm distance from the swith when the ventilating fan and
the power supply cord This product is in strict conformity with all the valid directives of
European Union applying on this type of electrical appliances.
9