Table of Contents
Advertisement
RED WIRE
The RED wire should be connected directly to the battery's positive terminal and fused with a 30A fuse.
BLACK WIRE
The BLACK wire should be directly connected to the battery's negative terminal
BLUE WIRE
The BLUE wire needs to be connected to 12v+ accessory circuit of your vehicle or remote turn-on out put of your
source/head unit.
RCA INPUTS
Connect the RCA inputs to the signal source of your choice.
GAIN SETTING
The gain control is NOT a volume control. The gain control adjusts the amount of signal required to drive the
amplifier to full output. With the gain at full clockwise rotation, less signal voltage is required to drive the amp to
full output. With the gain at full counter clockwise rotation, more signal voltage is required to drive the amp to full
output. For optimal performance, set the gain control to minimum
the bass level desired.
Low Pass Filter (LPF)
The Lowpass crossover/filter is designed to remove high frequency information from a speaker. This is generally
used to prevent mid bass speakers or subwoofers from trying to reproduce mid and high frequency information
that they are not designed to reproduce. The crossover frequency is adjustable from 50Hz to 200Hz. To adjust the
LPF turn the pot clockwise to raise the frequency and counter clockwise lowers the frequency. Most subwoofers
should be set between 80Hz and 100Hz depending on how low the mid-bass or midrange drivers are capable of
playing.
BASS KNOB
The included bass knob can be connected and mounted to a desired location to allow easy trim adjustment of the
bass level after the gain has been set.
GROUND WIRE
REMOTE WIRE
Wiring Instructions
RGB WIRE
RCA INPUT
50Hz
DESIGNED & DEVELOPED
IN THE UNITED STATES
3.5MM CONNECTOR FOR REMOTE
POSITIVE POWER WIRE W/ FUSE HOLDER
POWER
LPF
LOW PASS FILTER
200Hz
GAIN SETTING
MIN
MAX
GAIN
Advertisement
Table of Contents
