wamovo Skylight Mounting Instructions page 2

(GB) Mounting instructions
1
Before mounting, check the roof thickness of your
vehicle (suitable roof thickness: 25 - 60 mm). Make
sure that a 12V supply line has been laid from the roof
cut-out to the power supply.
4
Apply the sealing material in the sealing channel
of the upper frame, observing the instructions of
the sealant manufacturer.
7
Now remove the lamp covers of the inner
frame and connect the 12V supply cable for
the LED lighting.
Skylight 700 x 500
2
Select the installation position. Draw the cutout
size of the roof hood on the roof. Cut out +3 mm
(e.g. for 700 x 500 mm cut out accordingly 703 x
503 mm).
5
Place the skylight hood into the roof cutout from
the top, making sure that the hinges are facing the
front of the vehicle.
8
Place the roller blind in position and fix it in place
using the appropriate screws. Then refit the lamp
covers.
Freizeitschmiede GmbH & Co. KG · Robert-Bosch-Str. 12 · 51674 Wiehl · Germany
www.freizeitschmiede.com · Made in China
Skylight 450 x 400
3
Remove adhesive residues and thoroughly
clean the roof cutout in the mounting area.
6
Insert the provided brackets into the slots in the
skylight hood and use the provided screws to
secure them, depending on the thickness of the
roof.
CAUTION: Do not overtighten screws as this
may cause the roof cowl to warp.
NOTE:
- The roof hood must be installed with the
hinge side facing in the direction of travel.
- Never step on the dome of the roof
hood!
- Do not drive with the roof hood open.
Before driving off, make sure that the roof
hood is closed and locked.
- Do not open the roof window in strong
wind or rain.
- Close the skylight when it is raining or
snowing.
- Use only clear water and a soft sponge.
- Sharp cleaning agents can attack the
plastic and make it brittle.