Battery Installation The Judge Digital Scale takes ■ 2 x 1.5V AAA batteries. Remove the battery cover as shown ■ and install batteries according to the polarity markings. Please remove the batteries before ■ long term storage. LCD Display Zero Weight...
Before use 1. Wash bowl in warm soapy water, dry thoroughly and return to scale. 2. Install batteries as detailed. 3. Place on a solid, flat surface. Everyday Weighing 1. Short Press the button to turn the scale on. 2. Wait until the LCD display shows “0”.
Mode Selection Short press the button to change between Weight, Milk Volume and Water Volume modes. Water Volume Milk Volume Weight Mode Mode Mode Metric and Imperial Measurement Selection Long press the button change between Metric (g/ml) and Imperial measurements (lb:oz/fl‘oz) Long Press...
Water/Milk Volume mode 1. Short Press the button to turn the scale on. 2. Wait until the LCD display shows “0”. 3. Short Press the button to select water measurement (or Short Press again for milk measurment). 4. Add water to the bowl. 5.
Page 6
Add Weigh/Tare Mode Function Note: Tare Mode can only be used if the total initial load is greater than 200g. Tare mode allows you to weigh consecutive items without removing the previous item from the scale. Add Item A 1. Place Item A into the bowl. Weight of Item A is displayed.
Manual Shut Off Long press the button. Auto Shut Off (Power Saving Mode) Auto shut off occurs is the display shows ‘0’ or the same weight reading for more than a couple of minutes. Error Codes Err Overload Scale is loaded past the maximum warning capacity (5kg) - Remove items to avoid damaging the scale.
Page 8
TWO YEARS from the OR ACCUMULATED DIRT) date of original retail purchase. WITHOUT FOLLOWING THE USE, CARE & SAFETY During this period, JUDGE will, ■ INSTRUCTIONS. at their option, repair or replace defective parts of the product, or...